Friday, June 3, 2011

How do I go about changing the fuel filter on a 94 Explorer?

the 94 Explorer has a fuel shut off switch that is located on the passenger side or the %26#039;hump%26#039; under the carpet. Activate the switch or turn off the fuel pump.





Crank or turn yoru vehicle over several times. If it starts wait for it to stop. If it doesn%26#039;t start, you know the pressure is released.





If I remember correctly, your filter is located on the driver%26#039;s side, onthe inside of the frame rail. Unbolt the bracket, and follow the instructions that come with the filter to remove and install.





You can find exact instructions in a Chilton or Haynes manual for your vehicle.





At any rate, good luck.|||Locate it. Take the fuel line off of each side of the filter. Put in the new filter and reattach the fuel lines.|||You have to have a special tool to get them off. They are under the car on the frame rail. There are two special clamps on it (one on each end) called Garter spring clamps. You have to slide a special %26quot;sleeve tool %26quot; up inside the clamp to release the spring as you pull the filter off.


OH yea%26#039;! Get ready to take a bath in gasoline too!|||give up on changing your own oil. its LESS than 20 bux at any service station an ya prolly even squeeze em for a cup of coffee

No comments:

Post a Comment